| |
| Bionaid™
Trioxysilver™ Professional Bioavailability
Comparison Test: |
Test
the bioactive crystallization test on 6PPM Bionaid™
Trioxysilver™ Professional lot BT777 compared to
the best selling silver hydrosol on the market - 10PPM
Sovereign Silver lot BX14.
It does not matter what PPM a product is if it is not
bioactive. We have tested Bionaid™ Trioxysilver™
Professional and found that even at 6PPM it is more bioactive
than even the best selling products on the market at 10PPM.
If a particle of silver is bioactive it will crystallize
when it comes into contact with certain minerals such
as sodium. A lab will only tell you what the PPM is and
will not show you its bioavailability, i.e., the ability
of the particle to interact with pathogens or, in the
case of our test, other minerals.
Below is a bioavailability comparison of 10PPM Sovereign
Silver (Left) and 6PPM Bionaid™ Trioxysilver™
Professional (Right). A Sovereign Silver box was used
to hold each pen light flash light so the height of entry
was exact.

Notice how even at 6PPM Bionaid™
Trioxysilver™ Professional has complete crystallization
throughout the product when a sodium catalyst is
added. |
The Bionaid™ Trioxysilver™
Professional bottle lights up significantly when compared
to the 10PPM Sovereign Silver.

This picture shows an additional
bottle with just water and reagent. |
Water with zero bioavailable particles
will remain clear when a reagent such as sodium is added.
Bioavailability
~ Extent to which - and sometimes rate at which - the
active moiety (substance or metabolite) enters systemic
circulation, thereby gaining access to the site of action.
The physicochemical properties of a substance govern its
absorptive potential, but the properties of the dosage
form (which partly depend on its design and manufacture)
can largely determine substance bioavailability.
Sovereign Silver
10PPM on left; Trioxysiler 6PPM Bionaid™
Trioxysilver™ Professional on right; Picture
of Bionaid™ Trioxysilver™ Professional
Lot Number tested at center. |
As a side note, we would like for you
to notice that Bionaid™ Trioxysilver™ Professional
is in a clear bottle as a finished product. This is because
we want to make the point that Bionaid™ Trioxysilver™
Professional is not adversely affected by sunlight. All
of the other silver products we have seen on the market
have been bottled in a tinted bottle to protect it from
the sunlight because sunlight will cause the suspended
silver to fall out of suspension and change color.
We have also advanced The Water™ technology in Bionaid™
Trioxysilver™ Professional, and according to our
analysis The Water™ in Bionaid™ Trioxysilver™
Professional is producing an energy field well over a
mile away from the bottle from the latest advancements
in The Water™, and we are confident that the energies
put into the product, energies that we did not want to
escape from the contents, are adhering to the trioxysilver
particle to our satisfaction. Before, we used a tinted
bottle because we wanted to be sure the energies stayed
in the bottle.
Picture of Sovereign
Silver Lot BX14 tested at 10PPM. |
Home Test:
Take one bottle of Bionaid™ Trioxysilver™
Professional and place a 1/16 teaspoon of salt in it.
Shake it for 60 seconds and then let it sit for two minutes.
In a dark to low lit area place a pin light flash light
(one that can focus) up against the side of the bottle.
If the product was 1PPM or lower a haze may be slightly
perceptible but there will be no strong visible light
beam as can be seen in our sample tests of this Lot.
After this empty the bottle and wash it out completely
and rinse several times with filtered water. Place another
1/16 teaspoon of salt in the bottle and fill it with filtered
water. Shake for 60 seconds and let sit for two minutes.
This will be the bench mark of zero PPM. Do the same test
with other products.
Every lot is checked for PPM and bioavailability before
it is bottled. We stand by our belief that 6PPM Bionaid™
Trioxysilver™ Professional is more bioactive and
hydrating than any major brand of silver hydrosol or colloidal
silver on the market. Bionaid™ Trioxysilver™
Professional sets the standard.
|
|